Datalogic PowerScan D8300, Reference Manual

Page: 158 / 245

Enter Configuration Exit and Save Configuration
Ì$+;Î
16-KEY DK MODEL PARAMETERS
Ì$-?Î
149
SCANNER DATA HEADER/TERMINATOR
Scanner Data Header/Terminator creates an optional Header and Terminator data format
added to a barcode read from the device.
NOTE: Keyboard data format enable/disable (on previous page) must be used to enable the
Header and Terminator setup, so the two parameters should be combined to get the desired
result.
HEADER

no header
one character header
two character header


three character header
four character header


five character header
six character header


seven character header
eight character header


After selecting one of the desired Header codes, read the character(s) from the HEX table.
Valid characters are in the range 00-FE . For Wedge and USB-KBD interfaces, it is also possible
to read the Special Key(s) on page 74.
Example :
Four character header Hex codes Header
Read +
41 + 42 + 43 + 44
=
ABCD
For more details see par. 5.4.1 and par. 5.4.2. See also “Message Formatting” in par. 6.1 and
6.2.