Enter/Exit Programming Mode
Product Reference Guide
257
Set String Terminator
Sets the terminator of the predefined strings.
$CPWEF
Set String Terminator
To configure this feature, scan the ENTER/EXIT PRO-
GRAMMING MODE bar code above, then the bar code
at left followed by 32 digits from the Alphanumeric
characters in
The digits must be the hexadecimal ASCII representa-
tion of the desired characters. If less than the
expected string of 16 characters are selected, scan the
ENTER/EXIT bar code to terminate the string.
If the first 2 digits are 0, the feature is disabled. End by
scanning the ENTER/EXIT bar code again.
Make a mistake? Scan the CANCEL bar code to abort
and not save the entry string. You can then start
again at the beginning.
~
CANCEL
Summary of Contents for PowerScan 950X Series
