Enter/Exit Programming Mode
Product Reference Guide
79
Flash Off Time
This feature specifies the OFF time for the indicator LED while in Flash
Mode. The selectable range is 100 to 9,900 milliseconds (0.1 to 9.9 sec-
onds), in 100 millisecond increments. See
in “References” for
detailed information on setting this feature.
Select Flash OFF Time Setting
To configure this feature, scan the ENTER/EXIT
PROGRAMMING MODE bar code above, then the bar
code at left followed by the digits from the Alphanu-
meric characters in
repre-
senting your desired character(s). End by scanning
the ENTER/EXIT bar code again.
Make a mistake? Scan the CANCEL bar code to abort
and not save the entry string. You can then start
again at the beginning.
CANCEL
DEFAULT
06 = Flash is OFF for 600ms
Aiming Pointer
Enables/disables the aiming pointer for all symbologies.
Aiming Pointer = Disable
Aiming Pointer = Enable
DEFAULT
Summary of Contents for PowerScan 9501-AR Series
