Datalogic PowerScan 9501-AR Series, Product Reference Manual

Page: 230 / 362

Enter/Exit Programming Mode
220 PowerScan™ PD9531-AR/PBT9501-AR/PM9501-AR
Source Radio Address Delimiter Character
This option specifies the delimiter character to be placed between the label
data and radio address when address stamping is enabled.
Set Source Radio Address Delimiter Character
To configure this feature, scan the ENTER/EXIT
PROGRAMMING MODE bar code above, then the bar
code at left followed by the digits from the Alphanu-
meric characters in
Appendix D, Keypad
repre-
senting your desired character(s). End by scanning
the ENTER/EXIT bar code again.
Make a mistake? Scan the CANCEL bar code to abort
and not save the entry string. You can then start
again at the beginning.
CANCEL
DEFAULT
00 = No Delimiter Character
This feature only applies if
"Source Radio Address Transmis-
sion"
on page 219 is enabled.