Datalogic Pegaso, Product Reference Manual

Page: 21 / 172

Decoding
Product Reference Guide 2-7
1. Select
Start > Settings > Control Panel > Date/Time
.
2. Select the month to open a pull-down list of
months or tap the arrow buttons on either side of
the month to increase or decrease the month.
3. To change the year, select the year to open a
numeric dial. Select the up arrow to increase the
value; select the down arrow to decrease the
value. Or you can type a new year value in the
field.
4. To change the time, select the hour, minute, sec-
onds, or AM/PM and select the up arrow to
increase the value; select/tap the down arrow to decrease the value. Or you can
type a new time value in the field.
5. Select your correct time zone from the pull-down list.
6. To automatically adjust the clock for Daylight Savings Time, enable the checkbox
at the bottom of the screen.
7. Select
Apply
to save your changes and make additional modifications.
• Select
OK
to save your changes and exit
Date/Time Properties
.
• Select/tap the close button to exit without saving your changes.
Decoding
You can configure the Pegaso’s decoding options by tapping on
Start > Settings > Control
Panel > Decoding
. Decoder configuration can also be accomplished for large numbers of
terminals using
FMU
(Falcon Management Utility).
There are two sections in the
Decoding
control panel, each containing additional pages.
There are six General Configuration pages and multiple Bar Code symbology pages.
Configuration Control Panels
Select the desired configuration from the following options shown in Figure 2-5 , and
the other Decoding Properties figures on the following pages.
Use the pull-down menus or tap the left and right arrow keys to navigate the different
pages of the
Configure
utility.
Other decoding parameters are described in Programming Parameters, starting on
page F-1; bar code settings are provided in Programming Bar Codes, starting on
page G-1.