Datalogic MEMOR 20, User Manual

Page: 16 / 104

CONTENTS
10
MEMOR™ 20
BATTERY SAFETY GUIDELINES
WARNING: Installing, charging and/or any other action should be done by
authorized personnel and following this manual.
The battery pack may get hot, explode, ignite, and/or cause serious injury
if exposed to abusive conditions.
If the battery pack is replaced with an improper type, there is risk of explo-
sion and/or fire.
Do not place the battery pack in or near a fire or other heat source; do not
place the battery pack in direct sunlight, or use or store the battery pack
inside unventilated areas in hot weather; do not place the battery pack in
microwave ovens, in clothes dryers, in high pressure containers, on induc-
tion cook surfaces or similar devices. Doing so may cause the battery pack
to generate heat, explode or ignite. Using the battery pack in this manner
may also result in a loss of performance and a shortened life expectancy.
Use only a Datalogic approved power supply. The use of an alternative
power supply will void the product warranty, may cause product damage
and may cause heat, an explosion, or fire.
The area in which the units are charged should be clear of debris and com-
bustible materials or chemicals.
Do not use the battery pack of this terminal to power devices other than
this terminal. Immediately discontinue use of the battery pack if, while
using, charging or storing the battery pack, the battery pack emits an
unusual smell, feels hot, changes color or shape, or appears abnormal in
any other way.
Do not short-circuit the battery pack contacts connecting the positive ter-
minal and negative terminal. This might happen, for example, when you
carry a spare battery pack in your pocket or purse; accidental short–circu-
iting can occur when a metallic object such as a coin, clip, or pen causes
direct connection of the contacts of the battery pack (these look like metal
strips on the battery pack). Short–circuiting the terminals may damage the
battery pack or the connecting object.
Do not apply voltages to the battery pack contacts.
Do not pierce the battery pack with nails, strike it with a hammer, step on
it or otherwise subject it to strong impacts, pressures, or shocks.
Do not disassemble or modify (i.e. bend, crush or deform) the battery pack.
The battery pack contains safety and protection devices, which, if dam-
aged, may cause the battery pack to generate heat, explode or ignite. In
case of leakage of liquid from the battery, avoid contact with liquid the skin
or eyes. If the contact occurs, immediately wash the affected area with
water and consult a doctor.
Do not solder directly onto the battery pack.
Do not expose the battery pack to liquids.
Avoid any knocks or excessive vibrations. If the device or the battery is
dropped, especially on a hard surface, you should take it to the nearest
Authorised Repair Centre for inspection before continuing to use it. Before
replacing the battery pack, turn off the device or put it in swap battery
mode (refer to the Memor 20 User's Manual).
Do not remove or damage the battery pack’s label.