Datalogic Matrix 120, Product Reference Manual

Page: 15 / 188

PRODUCT REFERENCE GUIDE 1
CHAPTER 1
RAPID CONFIGURATION
STEP 1 - CONNECT THE SYSTEM
The paragraphs in this step show a typical hardware setup depending on the Matrix 120
model and interface selection. Several other layouts are described in Typical Layouts.
Ethernet Connections
To connect the system in an Ethernet point-to-point configuration, you need the hard-
ware indicated in Figure 1. In this layout the data is transmitted to the Host from the
Matrix 120 on-board Ethernet interface by using a
CAB-ETH-M0x cable. There is no
need to use a crossover adapter since Matrix 120™ incorporates an autocross function.
Matrix 120 power and I/O device connections take place through the CBX connection
box using the CAB-1011 accessory cable.
When One Shot or Phase Mode Operating mode is used, the reader is activated by an
External Trigger (photoelectric sensor) when the object enters its reading zone.
Host
Ethernet Interface
Main Serial Interface (RS232 or RS422 Full-Duplex)
External Trigger (for One Shot or Phase Mode)




CAB-1011
CBX
CAB-ETH-M0x


Figure 1 - Ethernet Point-to-Point Layout