Datalogic Magellan 9300i, Product Reference Manual

Page: 118 / 520

Enter/Exit Programming Mode Imaging and CSS Features
106 Magellan™ 9300i / 9400i Scanners
Image Capture to the Host by Camera Button
Perform the following steps to set up the Camera Button.
1. Set the Camera Button feature to enabled
2. Set the Image Capture destination to host port
3. Press the camera button
Scanner will beep for a few seconds, then take picture and send the Image
Retrieval Event label to the POS to indicate image is ready. The data content of
the event label is:
A856102000239
The POS sends the picture retrieval command to initiate picture download from
the scanner. Format of the command is:
P\x02pG
The scanner sends the picture to the POS with the transmission format
described in the previous section, “Image Capture By Host Command”.
Camera Button Mode
This feature enables or disables the camera button.
Camera Button Mode = Disabled
Camera Button Mode = Enable
DEFAULT
05B000(CR)
05B001(CR)