Datalogic MAGELLAN 8500?, Product Reference Manual

Page: 248 / 456

6-134
Magellan
®
8500 Scanner
UPC-E 5-Digit Supplemental Label ID
This feature specifies a UPC-E 5-Digit Supplemental label ID to be added
to barcode data.
To set this feature:
1. Scan the SWITCH barcode.
2. Scan the barcode, SET UPC-E 5-DIGIT SUPPLEMENTAL
LABEL ID below. You’ll need to cover any unused barcodes on
this and the facing page to ensure the scanner reads only the bar-
code you intend to scan.
3. Scan the appropriate digits from the keypad in
Appendix C
that
represent the desired Label ID characters; entered as two hex
pairs. A table containing the
ASCII Character Set and their corre-
sponding Hex Values is available in the inside back cover of this
manual. ASCII parameters must be input by scanning a pair of
hexadecimal digits for each character. Thus, to set a two-character
value of AB, barcodes containing the digits ‘4’, ‘1’, ‘4’, and ‘2’
must be scanned. The selectable range for this option is any hex
value from 00 to FF.
4. Complete the programming sequence by scanning the SWITCH
barcode.
SET UPC-E 5-DIGIT SUPPLEMENTAL LABEL ID
NOTE
The programming feature, RS-232 Label ID Control , designates whether
the Label ID is transmitted as a prefix or suffix or if Label ID is disabled.