Datalogic MAGELLAN 8500 Omega, Product Reference Manual, Page: 121 / 436

Product Reference Guide
6-15
Motor Timeout
The Motor Timeout feature sets the time for automatically switching the
motor off when the scanner is not in use.
To set the Motor Timeout:
1. Scan the SWITCH bar code.
2. Scan your selection from the bar codes below. You’ll need to cover
any unused bar codes on this and the facing page to ensure that
the scanner reads only the bar code you intend to scan.
3. Complete the programming sequence by scanning the SWITCH
bar code.
MOTOR TIMEOUT = 5 MINUTES
NOTE
Laser safety requires that the laser switch off before the motor. If you set the
motor timeout shorter than the laser timeout, the motor and the laser will
both shut off when the motor timeout expires.