Datalogic MAGELLAN 8200, Product Reference Manual

Page: 109 / 440

Product Reference Guide
6-1
Section 6
Programming
Introduction to Label Programming
The programming bar code labels contained in this manual will allow you
to customize and configure features and settings for your scanner (scan-
ner/scale). To ensure full compatibility and proper function, use only the
programming bar codes in this manual and other product-specific publi-
cations to program scanner features.
This manual has been developed to make it quick and easy for users of all
levels to find the information needed to understand and configure fea-
tures. The following descriptions will help you to determine where to go
from here.
Understanding the Basics
If you have little or no prior experience with programming using bar code
labels, you should review the first few pages of this section to familiarize
yourself with the basics of scanner programming before performing any
changes to your configuration.
Integrating the Scanner With Your Host
System
Your scanner MUST be equipped with the correct hardware (interface
board, cable, etc.) to properly communicate with your host system. Con-
tact your dealer for information if you have questions about your scanner’s
hardware compatibility.
You may also want to contact the dealer or your system administrator if
you have no record of how your scanner was pre-programmed at the fac-
tory. Scanners are typically programmed with the default settings for spe-
cific interface types (see
Appendix E , Factory Defaults for more
information); however, your scanner may have been custom configured
with settings that are unique to your company or application.