Datalogic MAGELLAN 3200VSI, Reference Manual

Page: 188 / 206

CAUTION
The microSD card slot is spring loaded. Keep your finger lightly in place
atop the card until you are sure it is fully seated in place. See the illus-
tration on the following page.
Use your finger or thumbnail to push in on the top edge of the card to
be slightly below flush with the scanner enclosure when inserting or
removing the card. This will engage/disengage the spring mechanism.
Never insert tools or other foreign objects into the microSD card slot.
180 Magellan™ 3200VSI
6. If installed properly, you should immediately hear an audible signal upon
insertion or removal of a microSD card. Various operations will also be
indicated by the scanner’s good read LED.
microSD Card Removal
1. Push in gently using your finger or thumbnail to disengage and remove the
microSD card. Remember to keep your finger in place atop the card’s edge
to avoid accidentally “launching” the card from the spring-loaded slot.
2. Reconnect all cables which were disconnected earlier.
Autorun File Processing
After insertion of the card, the scanner will mount the microSD card and search
for the file “AUTORUN.DLS”. Embedded in that file is a validation pattern of the
ASCII strings “$START$” and “$END$” located at the respective starting and
ending of the file.
If the validation pattern is found, the file may contain any of the following com-
mands. The scanner will parse the file taking action according to these com-
mands. Filenames in italics specify a user-defined name.
Example AUTORUN.DLS file:
$START$ (required)
CONFIG,
FILENAME.TEX
DUMPSTATS,
FILENAME.TXT
DUMPCFG,
FILENAME.TEX
LOADSW,
FILENAME.BIN
$END$ (required)