LYNX™ BT
5
5.6 RADIO PARAMETERS – LYNX™ BT WITH OM-1000 BT
5.6.1 Batch
Mode
Batch mode allows codes to be stored in the gun on a FIFO basis whenever the
reader is out of range. If transmission cannot be successfully completed, then the
code is added to the list. When the reader returns in range, transmission of the codes
to the cradle resumes automatically.
5.6.2
Beeper Control for Radio Response
The data entry good read tone normally results in two beeps; the first indicates that
the reader has decoded the code, the second indicates whether the cradle has
received the data.
This can be changed according to the following selections:
♦
Good Decode and Good Reception: both good decode and good reception are
signaled (two beeps).
♦
Only Good Decode: only the first beep indicating a good read is signaled.
♦
Only Good Reception: only the second beep indicating a good reception is
signaled.
♦
Off: Neither good read nor good reception beeps are signaled.
For all configurations, any transmission errors will always be signaled.
5.6.3 Transmission
Mode
This parameter determines whether the reader receives responses from the Host or
not. In One-Way tx mode, neither Host nor cradle responds to the reader.
In Two-Way tx mode, the reader must receive a response from either the cradle or
the Host.
134
Summary of Contents for lynx bt
