Datalogic Heron HD3430, Product Reference Manual

Page: 256 / 310

References
246 Heron™ HD3430
Global Prefix/Suffix
Up to 20 ASCII characters may be added as a prefix (in a position before the bar
code data) and/or as a suffix (in a position following the bar code data) as indi-
cated.
Figure 5. Prefix and Suffix Positions
Prefix S uffix AIM ID L a bel ID L a bel ID B a r Code D a t a
00 - 20 Ch a r a cters (A S CII)
AND
OR
OR...
Example: Setting a Prefix
In this example, we’ll set a prefix for all symbologies.
1. Determine which ASCII character(s) are to be added to scanned bar code
data. In this example, we’ll add a dollar sign (‘$’) as a prefix.
2. Go to page 74 and scan the ENTER/EXIT PROGRAMMING MODE bar code,
then scan the SET GLOBAL PREFIX bar code.
3. Reference the ASCII Chart on page 299 on the inside back cover of this man-
ual to find the hex value assigned to the desired character. The corre-
sponding hex number for the ‘$’ character is 24. To enter this selection
code, scan the ‘2’ and ‘4’ bar codes from
Appendix D, Keypad .
NOTE
If you make a mistake before the last character, scan the CANCEL bar
code to abort and not save the entry string. You can then start again
at the beginning.
4. If less than the expected string of 20 characters are selected, scan the
ENTER/EXIT bar code to terminate the string.
5. Scan the ENTER/EXIT bar code once again to exit Programming Mode.
6. The resulting message string would appear as follows:

Scanned bar code data:
12345

Resulting message string output:
$12345