Datalogic Gryphon Series, Product Reference Manual

Page: 247 / 333

Enter/Exit Programming Mode RF Address Stamping
244 Gryphon™ I GD44XX / GBT4400/GM440X
Source Radio Address Delimiter Character
This option specifies the delimiter character to be placed between the label data and radio
address when address stamping is enabled.
Link Timeout
This feature specifies the wait time in one-second ticks for response from the remote. The
selectable timeout range is 01 to 40 (01-0x28) seconds in one second increments.
See page 258 for more information on setting this feature.
This feature only applies if "Source Radio Address Transmission" on
page 243 is enabled.
Set Source Radio Address Delimiter Character
To configure this feature, scan the ENTER/EXIT PRO-
GRAMMING MODE bar code above, then the bar code
at left followed by the digits from the Alphanumeric
characters in
Appendix D. Keypad
representing your
desired character(s). End by scanning the ENTER/EXIT
bar code again.
Make a mistake? Scan the CANCEL bar code to
abort and not save the entry string. You can then
start again at the beginning.
CANCEL
$CBTAD
~
DEFAULT
00 = No Delimiter Character
Set Link Timeout
To configure this feature, scan the ENTER/EXIT
PROGRAMMING MODE bar code above, then the
bar code at left followed by the digits from the
Alphanumeric characters in
Appendix D. Keypad
representing your desired character(s). End by
scanning the ENTER/EXIT bar code again.
Make a mistake? Scan the CANCEL bar code to
abort and not save the entry string. You can then
start again at the beginning.
CANCEL
$CBTLT
~
DEFAULT
02 Link Timeout value is 2 seconds