Datalogic Gryphon I GM440 Series, Product Reference Manual

Page: 59 / 350

Enter/Exit Programming Mode
Product Reference Guide 49
Disable Character
Specifies the value of the RS-232 host command used to disable the reader.
ASCII characters or any hex value from 0 to 0xFF can be selected.
Setting to previously defined characters such as XON, XOFF, or host commands conflicts
with normal operation of these characters. 8-bit data is not recognized when the option
Data Bits
has been set as 7 Data Bits.
See page 278 for more information on setting this feature.
$CR2DC
Select Disable Character Setting
Enable Character
Specifies the value of the RS-232 host command used to enable the reader.
ASCII characters or any hex value from 0 to 0xFF can be selected.
Setting to previously defined characters such as XON, XOFF, or host commands con-
flicts with normal operation of these characters. 8-bit data is not recognized when the
option
Data Bits
has been set as 7 Data Bits.
See page 279 in “References” for more information on setting this feature.
$CR2EC
Select Enable Character Setting
DEFAULT
0x44 = Disable Character is ‘D’
DEFAULT
0x45 = Enable Character is ‘E’