Datalogic Gryphon I GFE4500, Product Reference Manual

Page: 92 / 312

ENTER/EXIT PROGRAMMING MODE READING PARAMETERS
78
GRYPHON™ GFS4500
Stand Mode/Object Detection Indication (Stand Mode Flash)
This operation is useful for indicating when the reader is in Stand Mode. If enabled, the
blue indicator will blink when Stand Mode scanning is active.
Stand Mode/Object Detection Sensitivity
Sets the sensitivity level for stand mode/object detection wakeup. Choices are values
between 00 (very low sensitivity) to 10 (very high sensitivity).
Default value is 04 (medium sensitivity).
$CSMFL00

Stand Mode/Object Detection Indication = Disable
Stand Mode/Object Detection Indication = Enable
$CSMFL01
Stand Mode/Object Detection Sensitivity
$CSMSE
To configure, scan the ENTER/EXIT PROGRAMMING
MODE bar code above, then the bar code at left fol -
lowed by the digits from the Alphanumeric charac -
ters in Appendix E, Keypad representing your
desired character(s). End by scanning the ENTER/
EXIT bar code.
Make a mistake? Scan the CANCEL bar code to abort
and not save the entry string. You can then start
again at the beginning.
CANCEL

04