Datalogic Gryphon I GFE4500, Product Reference Manual

Page: 90 / 312

ENTER/EXIT PROGRAMMING MODE READING PARAMETERS
76
GRYPHON™ GFS4500
Scanning Active Time
This setting specifies the amount of time that the reader stays in scan ON state once the
state is entered. The range for this setting is from 1 to 255 seconds in 1-second incre -
ments. See
page 238
in “References” for further description of this feature.
Double Read Timeout
Double Read Timeout prevents a double read of the same label by setting the minimum
time allowed between reads of labels of the same symbology and data. If the unit reads
a label and sees the same label again within the specified timeout, the second read is
ignored. Double Read Timeout does not apply to scan modes that require a trigger pull
for each label read.
$CSNET03
Scanning Active Time = 3 seconds

Scanning Active Time = 5 seconds
$CSNET05
$CSNET08
Scanning Active Time = 8 seconds
$CSNDR0A
Double Read Timeout = 0.1 Second
Double Read Timeout = 0.2 Second
$CSNDR14
$CSNDR1E
Double Read Timeout = 0.3 Second