Datalogic Gryphon I GD44XX, Product Reference Manual

Page: 47 / 324

Enter/Exit Programming Mode
Product Reference Guide 45
Intercharacter Delay
This parameter specifies the intercharacter de
lay be
tween the end of one character and the
beginning of the next. The delay can be set within a range of zero (0) to 990 milliseconds in
10ms increments. A setting of zero specifies no delay.
See page 257 for more information.
$CR2IC00(CR)
Intercharacter Delay = No Delay
$CR2IC
Select Intercharacter Delay Setting
To configure this feature, scan the ENTER/EXIT
PROGRAMMING MODE barcode above, then the
barcode at left followed by the digits from the
Alphanumeric characters in
Appendix D, Keypad
representing your desired character(s). End by
scanning the ENTER/EXIT barcode again.
Make a mistake? Scan the CANCEL bar code to abort
and not save the entry string. You can then start again at
the beginning.
~
CANCEL
DEFAULT
00 = No Intercharacter Delay