SETUP
6
GRYPHON™ I GD/GBT/GM4200
Figure 2. Cable Connection/Disconnection at the Scanner
RS-232 Serial Connection
Turn off power to the terminal/PC and connect the scanner to the terminal/PC serial
port via the RS-232 cable as shown in Figure 3. If the terminal will not support POT
(Power Off the Terminal) to supply scanner power, use the approved power supply (AC
Adapter). Plug the AC Adapter barrel connector into the socket on the RS-232 cable con-
nector and the AC Adapter plug into a standard power outlet.
RS-232:
The scanner can communicate with a standard or Wincor-Nixdorf (W-N) RS-
232 host.
RS-232 OPOS:
This interface is used for OPOS/UPOS/JavaPOS systems.
Keyboard Wedge Connection
The Keyboard Wedge cable has a ‘Y’ connection from the scanner. Connect the female
to the male end from the keyboard and the remaining end at the keyboard port at the
terminal/PC.
Keyboard Wedge (KBW):
When connected using this interface, the host interprets
scanned data as keystrokes and supports several international keyboards (for the Win-
dows® environment). See "
Setting Country Mode" on page 49
for a full listing.
USB Connection
Connect the scanner to a USB port on the terminal/PC using the correct USB cable for
the interface type you ordered.
USB:
Select to communicate either by USB OEM, USB COM STD, or USB Keyboard inter-
face types by scanning the appropriate interface type bar codes available in this manual.
The default interface is USB-KBD, or RS-232-STD.
Paper Clip
Cable Connector
Summary of Contents for Gryphon GBT4200
Page 14: ...PREFACE xiv GRYPHON I GD GBT GM4200 NOTES ...
Page 290: ...KEYPAD 276 GRYPHON I GD GBT GM4200 1 2 3 4 5 6 7 8 9 ...
Page 303: ......