Datalogic Gryphon BT4102, Product Reference Manual

Page: 94 / 354

ENTER/EXIT PROGRAMMING MODE
92 Gryphon™ I GD4132/GM4102/GBT4102
Set Global Mid Label ID Characters
Specifies mid-label ID that is added for transmission between the labels of a
two-label pair.
To configure this feature, scan the ENTER/EXIT PROGRAMMING MODE barcode
above to place the unit in Programming Mode, then the “Set Global Mid Label ID
Character(s)” barcode followed by the digits (in hex) from the Alphanumeric
characters in Appendix D, Keypad representing your desired character(s). If less
than the expected string of 20 characters are selected, scan the ENTER/EXIT
barcode to terminate the string. Exit programming mode by scanning the
ENTER/EXIT barcode again.
Set Global Mid Label ID Character(s)
Make a mistake? Scan the CANCEL barcode to abort and
not save the entry string. You can then start again at the
beginning.
CANCEL
DEFAULT
No Mid Label ID
Character (00)