Datalogic GRYPHON BT Series, Quick Reference

Page: 14 / 92

DATALOGIC
6
UK/US
NOTE
If the PIN of the Bluetooth
®
Master device cannot be disabled, use
the PIN "1234". The Gryphon™ BT Slave will emit four ascending
tones indicating radio connection.
After the Gryphon™ BT reader indicates radio connection (see the table at
page 7), you can start sending barcodes.
If the Master remote Bluetooth
®
device can support a piconet, the
communication can be established with up to 7 Slave readers at the same time.
Gryphon™ BT as Master
A Gryphon™ BT is Master when the remote Bluetooth
®
device is Slave, i.e.
with a Bluetooth
®
barcode printer. Once set as Master, a Gryphon™ BT reader
must be configured with the address of the Slave device to which it wants to
communicate.
By default, at startup the reader initializes the communication with the Slave. If
the connection is successful, the reader can send barcodes to the Slave
device.
If the connection is not successful, you can attempt a connection manually by
double-clicking the reader trigger. Radio connections can also be managed
manually as described in the Gryphon™ BT Reference Manual on the
configuration CD-ROM.
During the request of radio connection or disconnection with a remote
Bluetooth
®
Slave device, the reader emits a series of ticks and short blinks of
the blue LED.
SLEEP STATE
The
µ
P in the reader enters a “Sleep” state after 5 minutes of no reading for
minimum power consumption.