Datalogic DSM0400, Product Reference Manual

Page: 72 / 252

Enter/Exit Programming Mode
64 DSM0400 Fixed Mount Area Imager Bar Code Reader
Flash Off Time
This feature specifies the OFF time for the indicator LED while in Flash Mode.
The selectable range is 100 to 9,900 milliseconds (0.1 to 9.9 seconds), in 100
millisecond increments. Always use two digits (e.g.: scan the barcode '0' and
the barcode '2' for setting 0.2 seconds.) For more detailed programming
instructions, see "Flash Off Time" on
Chapter 4, References .
Select Flash OFF Time Setting
To configure this feature, scan the ENTER/EXIT bar code
above, then the bar code at left followed by digits from
the Alphanumeric characters in
Appendix C
represent-
ing your desired character(s). End by scanning the
ENTER/EXIT bar code again.
Make a mistake? Scan the CANCEL bar code to abort and
not save the entry string. You can then start again at the
beginning.
CANCEL
DEFAULT
05 = Flash is OFF for 500ms