Datalogic DM3610, Reference Manual, Page: 9 / 157

vii
WARNING:
Disconnect the power supply when installing the device or during
maintenance to avoid exposure to hazardous laser light.
WARNING:
There are no user serviceable parts inside the DM3610. Service should
only be performed by Datalogic trained and certified technicians.
The laser diodes used in this device are classified as Class 3B laser products according
to EN 60825-1 regulations and as Class IIIb laser products according to CDRH
regulations. Any violation of the optic parts in particular can cause radiation up to the
maximum level of the laser diode (30 mW at 658 nm typical).
POWER SUPPLY
This system is intended to be installed by Qualified Personnel only.
The DM3610 dimensioner is intended to be supplied by a UL/CE Listed power supply marked
SELV (Separated Extra Low Voltage), output rated 24 VDC, minimum 4.0 Amp.
UL LISTING
UL Listing
CE COMPLIANCE
WARNING:
This is a Class A product. In a domestic environment this product
may cause radio interference in which case the user may be required to take
adequate measures.
FCC COMPLIANCE
Modifications or changes to this equipment without the expressed written approval of
Datalogic could void the authority to use the equipment.
This device complies with PART 15 of the FCC Rules. Operation is subject to the following
two conditions: (1) This device may not cause harmful interference, and (2) this device must
accept any interference received, including interference which may cause undesired
operation.