Datalogic DM3610, Reference Manual, Page: 45 / 157

MECHANICAL INSTALLATION
35
2
2.4.20 Connect Communication and Power Cables to the Installation
WARNING:
DO NOT connect the power supply to a power source until
after all wiring connections have been made to the DM3610, DC3000 and
CBX510.
Connect all communication cabling for the two-head system as explained in
chapter 3,
Electrical Installation , including:

Communications and power supply connections to the DM3610
Figure 35: Connections to the DM3610 Connector Panel

Ethernet connection to the DC3000 Controller

Connections to the CBX510 connection box

Connections to a photoelectric sensor

Connections to a tachometer

Connections to a remote display

Serial communication (if used)
After the communications cables have been connected, connect the power supply cables to
the DM3610s, and then attach the power supply to a power source.
NOTE:
For information on setting up network or serial communication
parameters, see chapter 4, User Interface .
2.5 CALIBRATION AND SETUP