Datalogic DM3610, Reference Manual, Page: 141 / 157

MAINTENANCE
131
6
6.2 MAINTENANCE TASKS
Perform the maintenance tasks on an “as needed” basis to assure proper operation of the
DC3000 Dimensioning Controller and DM3610 Dimensioner. Task schedule frequency
depends upon the application environment conditions. It only requires a few minutes to
complete each maintenance task.
6.2.1 Exterior Cleaning
WARNING:
Shut down the DC3000 and DM3610 before performing this
maintenance task. Do not stare into the
DM3610 Dimensioner’s exit window
at the laser light. Avoid direct eye exposure. The laser light level does not
constitute a health hazard, however staring at the laser light for prolonged
periods could result in eye damage.
CAUTION:
Do not use any chemical on the DC3000 Dimensioning
Controller or DM3610 Dimensioner that is unsafe for plastics, such as
benzene, acetone, or similar products. Before performing this maintenance
task, be sure to shut down the device.
The exterior cleaning procedure may be performed without removing the DC3000
Dimensioning Controller or DM3610 Dimensioner from the mounting structure.
1. Turn off the device by disconnecting the power source.
2. Clean the exterior (except the exit window) with a clean, soft-bristle brush. Be sure
not to brush any dust, dirt, or debris onto the exit window. Make sure the cooling fins
of the DC3000 Dimensioning Controller are free of dust and debris.
3. Carefully remove any debris in or around the exit window of the DM3610
Dimensioner.
4. Wipe the exterior of the DM3610 Dimensioner (except the exit window) with a clean,
soft cloth dampened slightly with a mild detergent solution.
5. The of the DM3610 Dimensioner exit window should be cleaned after this task is
completed.