Datalogic DM3610, Reference Manual, Page: 140 / 157

TWO-HEAD DIMENSIONING SYSTEM REFERENCE MANUAL
130
6
6 MAINTENANCE
6.1 OVERVIEW
This chapter provides instructions for maintaining optimum performance and life for your
dimensioning system devices. It provides specific information on:

Maintenance Procedures

Exterior Cleaning

Mounting Hardware Checks

Wiring Connection Checks
Tools and Materials Required
Item Description
Soft-bristle brush For cleaning the DM3610
’s exterior
Clean, soft cloths For cleaning the DM3610
’s exterior
Cleaning solutions Mild detergent solution for cleaning the DM3610
’s exterior.
70% denatured alcohol, 30% de-ionized water solution for cleaning
exit window
Soft cotton swabs or
lint-free cloth Use to clean DM3610
reader’s exit window
IMPORTANT:
Due to the complex and application-specific nature of
dimensioning / certified dimensioning installations, the Multi-Head
Dimensioning System must be setup and serviced by authorized
technicians trained by Datalogic.
The maintenance procedures in this chapter may be performed by an end
user technician. Training is recommended if the end user intends to do
more than the maintenance procedures provided in this chapter.
There are no user serviceable parts within the DC3000 Dimensioning
Controller or DM3610 Dimensioner.
DO NOT OPEN THE UNITS. Opening
the device may void its warranty.
CAUTION:
Proceeding with any setup, calibration, or service procedures
without proper training may void the warranty.
Training is available through specific Service Programs and Maintenance
Agreements. See our website at
www.datalogic.com .
CAUTION:
RISK OF EXPLOSION IF BATTERY IS REPLACED BY AN
INCORRECT TYPE.
PROPERLY DISPOSE OF USED BATTERIES.