Datalogic DL9600 Viper, User Manual

Page: 32 / 56

DL9600 VIPER™
16
3
3.7 EXIT MENU
ITEM DESCRIPTION NOTES
CMOS+EEPROM
Save & Exit Saves the new values in the
CMOS memory and
EEPROM memory and exits. Press [S] to activate the
function.
CMOS Save & Exit Saves the new values in the
CMOS memory and exits. Press [C] to activate the
function.
Discard Discards the new values and
exits. Press [Q] to activate the
function.
Factory parameters Load the default factory
values. Press [D] to activate the
function.
3.8 EXIT FROM THE SETUP PROCEDURE
To end the SETUP procedure, you will have to:
1- Select the Exit menu by pressing [ESC]
2- Select one of the items by pressing the correct key (an erroneous one re-enters
the setup procedure):
−
If you exit with saving, a message appears notifying that the program is
about to quit, and you can choose to reboot the DL9600 terminal to see the
effects of the new configuration. Remember that the DL9600 terminal
parameters are used by BIOS at boot-time.
−
If you exit with the “Discard” command, no change will affect CMOS and
EEPROM memories.
−
If you choose the “factory parameters”, the application applies it and then re-
enters the setup procedure.