Datalogic AV7000, Reference Manual, Page: 245 / 337

IMAGING FEATURES
233
5
7.
Measure the conveyor width (the distance from the left side camera’s far working
distance point to the right side camera’s far working distance point measuring across the
conveyor) and add that value into
e-Genius. See section 4.5.1 Modify Settings | Global
Settings | Operating Mode.
8. Identify how many inches the Box Data is found from the center 0 found in the Center
Scale of the CodeWord Viewer. 0.
Example:

With a 28 inch wide conveyor, if the box is located exactly at the 0 (zero) line in the Code
Word Viewer Center Scale, a Left Ignore Limit of 14 and a Rig ht Ignore Limit of 15 is
entered into the AV7000 e-Genius RangeFinder parameters (See 4.5.1 ).
In the example above the box is found on the one inch increment mark of the Center
Scale line. Since the box is on the positive side of the 0 reference then the following
values will be added into the left/right field if the RangeFinder mounting parameters:
Left:
–15
Right: +13
5.2.3 Setting up an AV7000 System Using an LCC-75XX KIT with DS2
Light Array
The DS2 AREAscan™ Light Array is a multibeam optoelectronic devices that can be used to
detect objects, including small and transparent targets as well as for measurement detection.
Reference the
DS2 Instruction Manual available at www.datalogic.com .
The device consists of emitter and receiver units, which generate infrared beams that detect
any object positioned in the light grid’s detection field.
The command and control functions are inside the two units; the connections are made
through M12 connectors located in the lower side of the profiles. The synchronisation
between the emitter and the receiver takes place via cable through direct connection