Datalogic AI7000, Product Reference Manual

Page: 257 / 352

SETTING UP THE STI LIGHT CURTAIN
PRODUCT REFERENCE GUIDE
243
Emitter Trimmer is set fully clockwise (maximum gain)
SETTING UP THE STI LIGHT CURTAIN
Reference the STI Light Curtain Instruction Manual available at STI.com for complete
information on connecting and aligning the Light Curtain. Make the following selections
in the AV7000 e-Genius application Operating Mode.
SETTING UP THE DK501 (S80) DISTANCE KIT
Reference the DK-501 Distance Kit Installation Manual for mounting and connecting the
S80 Distance Sensor
available at www.datalogic.com for information about the S-80
position sensor.
Mounting the S80 in an AV7000 System
In an AV7000 system, the S80 Distance Sensor must be mounted perpendicular to the
conveyor. If there is more than one, the first S80 must be mounted at least 127mm (5
inches) downstream from the trigger photoeye. The trigger photoeye and downstream
most S80 or Light Curtain must be mounted at least 127mm (5 inches) a part. The down-
stream most S80 or Light Curtain must be mounted at least 305mm (12 inches)
upstream from the first camera scan line. There is no required distance between each
S80/Light Curtain.
1. Mount the S80(s) and DL light curtain (if required), as previously described.
2. Connect the S80(s) to the focus serial port of the controller AV7000 in the tunnel.