MA1069 PWRM10-01 & PWRM20-01 Quick Start Guide
Page 12 of 16
6.0 Acquiring Data from the Module
Selections on the left side of the panel give full access to module configuration and all features and
functions.
6.1 Enter Sensing Device Parameters with Sensor Configuration
Data will not be accurate until phase voltage and phase current sensors are configured.
First go to the
Configuration | Sensor
page, select devices used to measure phase currents and
phase voltages, and enter the device parameters.
Figure 15: Configuration | Sensor Page
Custom scaling parameters are available if required by an installation.
6.2 Data Display in Tables
Data is continuously collected from the module at the default poll rate of 1 second and posted to the
appropriate displays and charts.
The
Data | Table
page has a concise tabulation of the basic parameters measured.
Figure 16: Data | Table Selection
