DataDirect Networks S2A9550, User Manual

Page: 34 / 118

Installation
22
DataDirect Networks S2A 9550 User Guide
To change the mapping mode:
1.
Type: tier changemap
<Enter>
2.
Then enter the appropriate mapping mode. Use Mapping Mode 0 for SF6016 and
SF6012 enclosures.
3.
For the changes to take effect, type: restart
<Enter>
.
NOTE : If you have other types of drive enclosures, select Tier Mapping Mode 0. The
S2A9550 might be able to monitor the status of your enclosures; however, DataDirect
Networks is unable to guarantee compatibility with unqualified third party devices.
2.3.7 Verifying Connections for SF6016 Enclosures
If you are using the SF6016 drive enclosures, it is necessary to verify the connections of
the enclosures that are currently attached to the system, so that SES can accurately
indicate a drive fault through SES commands. Please refer to Section C.3 and perform
all the steps described before proceeding to the next section.
2.3.8 Checking Tier Status and Configuration
Use the
tier
command to display your current tier status. Figure 2-7 illustrates the status
of a system containing 80 drives on 8 tiers with both parity modes of 8+1 and 8+2 tiers.
The plus sign (+) adjacent to the tier number indicates that the tier is in 8+2 mode.
Figure 2-6 Tier Mapping Mode Setup Screen
S2A (2): tier changemap
0) Standard Enclosure mapping.
1) SF-2012 Enclosure 1x12 mapping.
2) SF-4012 Enclosure 2x6 mapping.
3) SF-2016 Enclosure 1x16 mapping.
4) SF-4016 Enclosure 2x8 mapping.
5) SA-2016 Enclosure 1x16 mapping.
6) SA-4016 Enclosure 2x8 mapping.
7) SAF-2248 Enclosure 1x48 mapping.
8) SAF-4248 Enclosure 2x24 mapping.
9) SF-2416 Enclosure 1x16 mapping.
10) SF-4416 Enclosure 2x8 mapping.
11) SF-2012REM Enclosure 1x12 Removable mapping.
12) SF-4012REM Enclosure 2x6 Removable mapping.
13) SF-6016 Enclosure 5x3x1 mapping.
14) SF-6012REM Enclosure 6x2 Removable mapping.
Current mapping mode: 4, SF-4016 Enclosure 2x8.
Enter the new mapping mode (0..14), 'e' to escape: