CHECK II Quick Start Guide
Measuring Samples
27
Naming Samples before Measurement
To name a Standard
before
measuring, do the following:
1. Press the
Measure/Select
Standard
button
on far left
of the Control Panel.
2. Activate the cursor on the name line by touching the line.
3.
Tap the
abc
or
123
icon in the graffiti pad to display the
keyboard, and enter a name.
4. Tap the
Close
icon in the bottom right corner to close the
keyboard.
5. Place the stapler foot over the sample, and press the
Measure
button. The name you entered will be displayed
for the standard.
To name a batch before measuring:
Press the
Measure/Select Batch
on the Control Panel,
and repeat the procedure.
Naming Samples after the Measurement
Sample names can be edited at any time.
See Datacolor CHECK II
User’s Guide, for detailed instructions.
Storing and Retrieving Samples
Autosave is the default condition and every measurement is stored, in
the folder that is
currently selected
. All batch measurements are
attached to the standard that is active at the time of the measurement.
