![background image](http://html1.mh-extra.com/html/datacard/cr805/cr805_user-manual_3686106134.webp)
A-12
CLM Laminator
Clean the Laminator
Clean the laminator when at least one laminator cartridge is loaded with holographic overlay
material and any of the following are true:
Particles appear on the laminated cards.
Particles are visible inside the laminator.
For examples of problems that require laminator cleaning, refer to
.
1.
Unlock and open the laminator access door.
2.
Remove the L1 and L2 laminator cartridges.
3.
Remove printed cards from the output hopper, if necessary.
This procedure uses a double-sided, sticky cleaning card that removes holographic
overlay particles from the laminator. When you clean the system using a sticky
cleaning card or isopropanol cleaning card, the card also moves into the laminator
and cleans the laminator rollers, the card entry area, and the impresser exit rollers.
This is sufficient if you are not using holographic overlay. Refer to
.
Summary of Contents for CR805
