![background image](http://html1.mh-extra.com/html/datacard/cr805/cr805_user-manual_3686106116.webp)
100
Troubleshooting
202: L1 supply out or missing
The laminator does not have usable supplies.
1.
Open the laminator.
2.
Replace the supply.
3.
Close the laminator.
On the PC, click OK, or click Cancel to cancel the card.
203: L1 supply type problem
The laminator cannot use the supply installed.
Use supplies designed for this laminator.
On the PC, click Retry, or click Cancel to cancel the card.
204: L1 supply not supported
The laminator cannot use the supply installed.
Use supplies designed for this laminator.
On the PC, click Retry, or click Cancel to cancel the card.
205: L1 supply not identified
The laminator cannot use the supply installed.
Use supplies designed for this laminator.
On the PC, click Retry, or click Cancel to cancel the card.
206: L2 supply problem
The L2 supply is not moving properly. To try another card:
1.
Open the laminator and remove the L2 cartridge.
2.
Reposition, repair, or replace the supply and advance the repaired area one full turn.
3.
Replace the cartridge and close the laminator.
On the PC, click Retry, or click Cancel to cancel the card.
Summary of Contents for CR805
