4 Using the control module
Clarity Controls
Adjust Time
This field can only be edited when the
Power Controller
checkbox is
selected.
Interference Filter
Possible values are
P
,
S
and
Sn
. This field is only present when using the
Flame photometric detector (FPD or WFPD).
Signal Type
Sets the type of the signal -
Wide
or
Linear
. The selection influences the
possible values present in the
Range
field.
H2 Flow
Turns On/Off the flow of hydrogen and sets its value. Available for FID,
WFID, WDFID, FPD, WFPD, SID, WSID, FTD and WFTD detector.
Make Up
Turns On/Off the flow of make-up gas and sets its value and type of the
gas. Available for FID, WFID, WDFID, FPD, WFPD, SID, WSID, FTD and
WFTD detector.
Air Flow
Turns On/Off the flow of the air and sets its value. Available for FID, WFID,
WDFID, FPD, WFPD, SID, WSID, FTD and WFTD detector.
Program …
Opens the dialog for setting the flow program. The tables allows to set the
flow program for the detector during the analysis. Available for FID, WFID,
WDFID, FPD, WFPD, SID, WSID, FTD and WFTD detector.
Fig 11: Method Setup - GC - DET1 - Program
- 14 -
