9
SHAN-TM700 tripod adapter plate shown without
riser block
10. Secure the ENG tripod adapter plate (not
supplied) and riser block
item N
(if
required) to the prompter rail
item A
using
two of the riser screws provided,
items L or
M
. These screws go through the long slot
on the riser block and prompter rail and into
the base of the tripod adapter plate.
Two screw sets are provided, the long set
(
Item M
31mm long) is for when using the
riser block. The short set (
Item L
16mm
long) when just using the camera plate on
its own.
Items Q and R
are provided in case the
tripod adapter plate and riser block need to
be positioned over the tripod head.
11. You can now mount the ENG camera to the
tripod adapter plate.
Take care
to protect
the camera lens and the 60/40 mirror glass.
If necessary slide everything further along
the prompter frame. The tip of the lens
should be about 1 to 2 cm away from the
60/40 Mirror Glass.
It may be a good idea to remove the lens
sun hood if this is possible.
12. Fit the Snood / Hood support wire,
item K
..
This stops the cloth Snood / Hood from
dipping in front of the camera lens. There
are two sets of holes in the glass frame for
this Snood / Hood support wire.
13. Fit the cloth Snood / Hood,
item I
, around
the lens and to the Glass Frame edges,
item G
. The Velcro strips marry the
Snood/Hood to the Glass Frame.
