Data Translation MACH Series, Getting Started Manual, Page: 27 / 62

Installing the Board
19
3
3
3
3
3
3
3
3
3
Setting up the Computer
Perform the following procedure to set up the computer:
1. Turn off the computer.
2. Turn off all peripherals (printer, modem, monitor, and so on)
connected to the computer.
3. Unplug the computer and all peripherals.
4. Remove the cover from you computer. Refer to your computer’s
user manual for instructions.
Next, select an expansion slot, as described in the next section.
CAUTION:
To prevent electrostatic damage that can occur when handling
electronic equipment, use a ground strap or similar device when
performing this installation procedure.