Data Translation DT9835, User Manual

Page: 35 / 80

Supported Device Driver Capabilities
25
3
3
3
3
3
3
3
3
3
P
ro
c
e
sso
r
Data Processing Capability
OLSSC_SUP_PROCESSOR
So
ftw
a
re
C
a
lib
ra
ti
on
Software Calibration Support
OLSSC_SUP_SWCAL
a. A total of eight banks of eight digital I/O lines and four banks of eight dedicated digital input
lines exist on the board. You can configure the nondedicated banks for either digital input or
digital output when you configure the device driver. Refer to the DT9835 Getting Started
Manual for more information on configuring the device driver.
b. Continuous digital input operations are supported by digital input banks 10 and 11 only.
c. The number of subsystem elements depends on the bank size or resolution established in the
driver configuration dialog. Values for resolution are 8, 16, 24, or 32; refer to page 12 for more
information on resolution.
d. Digital banks 10 and 11 can generate an interrupt on a bit-by-bit basis. You configure the
digital lines to interrupt using the Open Layers Control Panel. Refer to the DT9835 Getting
Started Manual for more information.
Table 2: DT9835 Supported Options (cont.)
DT9835 A/D D/A DIN DOUT SRL C/T
Total Subsystems on Board 0 0 12
a
8
a
0 0