Data Translation DT9834 Series, User Manual

Page: 107 / 186

Supported Device Driver Capabilities
107
Data Flow and Operation Options
Table 12: DT9834 Series Data Flow and Operation Options
DT9834 Series A/D D/A DIN DOUT C/T QUAD
Single-Value Operation Support
SupportsSingleValue Yes Yes Yes Yes
Simultaneous Single-Value Output
Operations
SupportsSetSingleValues
Continuous Operation Support
SupportsContinuous Yes Yes Yes
a
a. The DIN subsystem supports continuous mode by allowing you to read the digital input port
(all 16 digital input lines) using the analog input channel list.
Yes
b
b. The DOUT subsystem supports continuous mode by allowing you to output data from the
digital output port (all 16 digital output lines) using the output channel list.
Yes
c
c. The C/T subsystem supports continuous mode by allowing you to read the value of one or more
of the five counter/timer channels using the analog input channel list.
Continuous Operation until Trigger
SupportsContinuousPreTrigger
Continuous Operation before & after Trigger
SupportsContinuousPrePostTrigger
Waveform Operations Using FIFO Only
SupportsWaveformModeOnly
Simultaneous Start List Support
SupportsSimultaneousStart Yes Yes
Supports Programmable Synchronization
Modes
SupportsSynchronization
Synchronization Modes
SynchronizationMode
Interrupt Support
SupportsInterruptOnChange Yes
d
d. The first 8 digital input lines of the digital input port can generate an interrupt-on-change event.
You enable the interrupts on a line-by-line basis during driver configuration; refer to page 33 for
more information on configuring the driver. If you are using the DataAcq SDK, refer to page 95
for more information about determining which digital input lines changed state.
Output FIFO Size
FifoSize 128K
Auto-Calibrate Support
SupportsAutoCalibrate