Chapter 3
22
11.
If you wish to change the name of the board, click Edit Name and
enter a new name for the board. Otherwise, exit from the Control
Panel.
Once the driver is loaded, perform the steps in
to attach
and configure the screw terminal panel for use with the DT340 board.
Windows Me
In Windows Me, the driver is automatically loaded when you install
the DT340 driver from the Data Acquisition OMNI CD. To configure
the device driver, perform the following steps:
1.
Open the Control Panel.
2.
Double-click the Open Layers Control Panel icon.
3.
Select the DT340 board to configure, then click Advanced.
4.
Select the appropriate boxes to enable interrupts for lines (bits) 0
to 7 on digital port D, user counter/timers 0 to 7, and interval
timers 8 to 11.
5.
When you are finished, click Close.
6.
If you wish to change the name of the board, click Edit Name and
enter a new name for the board. Otherwise, exit from the Control
Panel.
Once the driver is loaded, perform the steps in
to attach
and configure the screw terminal panel for use with the DT340 board.
Summary of Contents for DT340
