Data Translation DT3157, Getting Started Manual

Page: 52 / 68

Chapter 5
44
Installing and Configuring the Driver in
Windows 2000
Perform the following steps to install and configure the device driver
in Windows 2000:
Note: This procedure assumes that no other MACH I Series drivers
(DT3152, DT3152-LS, DT3153, DT3154, DT3155, or DT3157) are
installed in your system. If you previously installed a MACH I Series
driver, refer to the Data Translation knowledgebase at
www.datx.com for information on removing the existing inf file
before performing this procedure.
1. If you have not already done so, power up your computer and
any attached peripherals.
Note: On power-up, the PCI bus takes one available interrupt
from system resources for the DT3157 board. If any devices are
using this interrupt, problems may arise. Verify that no other
devices in your system are using the same interrupt that the
DT3157 board is using and ensure that PCI interrupts are enabled
in your system BIOS.
2. Start Windows 2000.
The Found New Hardware dialog box appears.
3. Click Next .
4. Click Search for a suitable driver for my device (recommended) ,
then click Next.
5. Click Specify a location and uncheck all other checkboxes, then
click Next .