Data Translation DT3145, Getting Started Manual

Page: 19 / 60

Preparing to Use the DT3145
11
2
2
2
2
2
2
2
2
2
Installing the Software
To operate properly, the DT3145 frame grabber board requires the
following software components, which are provided on the Imaging
OMNI CD:
• Microsoft DirectX, version 7.0 or greater,
• DT3145 Device Driver, version 1.0 or greater.
Note: If the DirectX software on your computer is less than version
7.0, you are prompted to install the updated DirectX software from
the Imaging OMNI CD.
To install the DT3145-related software from the Imaging OMNI CD,
perform the following steps:
1. Insert the Imaging OMNI CD into your CD-ROM drive.
Typically, the software installation procedure starts automatically. If
the installation procedure does not start automatically, click
Run from
the Windows Start menu, either enter x:\LAUNCH.EXE (where x is
the letter of your CD-ROM drive) in the Run dialog box or use the
Browse button to locate LAUNCH.EXE, then click
OK .
2. From the main screen, click Install Products .
3. Click MACH II SERIES .
4. Click Install Devices .
5. Click DT3145 .
If you do not have an up-to-date version of DirectX installed on your
system, you are prompted to install DirectX software from the Imaging
OMNI CD; afterwards, you must repeat steps 1 to 5. If you do have an
up-to-date version of DirectX, the InstallShield Wizard appears.
6. Click Next .
The license agreement is displayed.