Chapter 3
22
Configuring the Device Driver
To configure the DT3130 Series Device Driver, perform the following
steps:
1.
Open the Control Panel.
2.
Double-click the
DT Imaging Control
icon.
3.
Select the DT3130 Series device to configure.
Note that the DT3131 and DT3131-ISO boards contain one device; the
DT3132 and DT3132-ISO boards contain two devices; and the DT3133
and DT3133-ISO boards contain three devices. Device 1 corresponds to
channels 0, 1, and 2; device 2 corresponds to channels 3, 4, and 5; and
device 3 corresponds to channels 6, 7, and 8.
4.
Select the
Video Format
as either 50 Hz or 60 Hz.
5.
When you are finished, click
Done
.
If you made any changes, the Save Changes dialog box appears.
6.
If you want to save your changes, click
Yes
.
When you are finished with this procedure, continue by connecting
signals to the board. Refer to
Summary of Contents for DT3130 Series
