Operation ■ Running a Job on PSV7000
—36—
Data I/O • 096-0461-001G
back
Note:
Actuator bar adjustments may vary depending on loca-
tion—the front half of the programmer or the far half.
(LumenX) Remove/Install Socket Adapters
CAUTION: Electrostatic discharge (ESD) hazard! Wear an ESD
strap or discharge static against a common ground to prevent
damage to Socket Adapters and devices.
1.
Pull the spring clip and lift open any socket clamp. One clamp
secures two Socket Adapters.
2.
Orient the Socket Adapter with the chamfered corners toward
the front (nearest to you). All locations orient the same.
CAUTION: Possible machine damage! Bent or damaged pins can
reduce yields or prevent programming. Do not touch connector
pins. Use caution installing adapters.
Figure 21: One clamp open with Socket Adapters. Two of the
alignment holes are circled. The two back alignment holes are not
visible in this view. Chamfers are to the front (arrows).
3.
Place the adapter to match the guide pin at each corner with the
holes in the adapter.
4.
(Optional) Place a second adapter at this clamp.
5.
Close the clamp. Make sure the latch snaps in place.
Removal is the reverse procedure. Lift gently by the socket.
