Data General AViiON Series, Customer Documentation

Page: 129 / 210

Connecting External Devices to VME Option Boards
4-29
014–001867
Slide clip
Cable connector (male)
Slide clip mounts
Connector pins
1–15
Drop cable (side view)
Figure 4–33 Aligning Slide Clip Mounts with a LAN Connector
4. Push the edge of the slide clip into position, so the small mount slot surrounds
its cable connector mount. Figure 4–34 illustrates how to secure a slide clip
connection.
Mount slot
(large)
Mount slot
(small)
VLC board
air dam
Cable connector mount
Cable connector mount
Figure 4–34 Connecting a LAN Drop Cable to a VLC Connector
If you haven’t already connected the remote end of the cable to your transceiver, do
so now. Refer to the device-specific documentation for your transceiver, if necessary.
Then continue with the next section that applies to your system.
When you finish connecting all external devices to your VME option board(s), refer
to your starting manual for instructions on powering up your system. You should
then refer to your operating system documentation for instructions on what to do
after booting or rebooting your system hardware.