Data Domain DD400 Series, User Manual

Page: 78 / 300

Additional Configuration
40 DD400 Series Restorer User Guide
Note For Tivoli Storage Manager on an AIX backup server to access a restorer, you must re-add
the backup server to the restorer after completing the original configuration setup. On the
restorer, run the following command with the
server-name of the AIX backup server:
# nfs add /backup server-name insecure
h. Configure the backup servers. For the most up-to-date information about setting up
backup servers for use with a restorer, go to the Data Domain Support web site
(
http://support.datadomain.com/ ). See the Technical Notes section.
Additional Configuration
The following are common changes to the restorer configuration that users make after the
installation. Changes to the initial configuration settings are all made through the command line
interface. Each change describes the general task and the command used to accomplish the task.
•
Add email addresses to the alerts list and the autosupport list. See “Add to the Email List” on
page 74 for details.
alerts add
addr1
[,
addr2
,...]
•
Give access to additional backup servers. See “NFS Management” on page 129 for details.
nfs add /backup
srvr1
[,
srvr2
,...]
•
From a remote machine, add an authorized SSH public key to the restorer. See “Add an
Authorized SSH Public Key” on page 60 for details.
ssh-keygen -d
ssh -l sysadmin rstr01 “adminaccess add ssh-keys” \
< ~/.ssh/id_dsa.pub
•
Add remote hosts that can use FTP or TELNET on the restorer. See “Add a Host” on page 59
for details.
adminaccess add {ftp | telnet}{all |
host1
[,
host2
,...]}
•
Enable HTTP, HTTPS, FTP or TELNET. The SSH, HTTP, and HTTPS services are enabled
by default. See “Enable a Protocol” on page 60 for details.
adminaccess enable {http | https | ftp | telnet | ssh | all}
•
Add a standard user. See “User Administration” on page 65 for details.
user add
username
•
Change a user password. See “User Administration” on page 65 for details.
user change password
username