User Manual
UMN:CLI
V8102
577
To specify an interval to send PIM join/prune messages, use the following command.
Command
Mode
Description
ipv6 pim jp-timer
<1-65535>
Global
Specifies an interval to send join/prune messages.
1-65535: join/prune message interval (unit: second)
no ipv6 pim jp-timer
[<1-65535>]
Deletes a specified interval to send join/prune messag-
es.
11.3.2.7
PIMv6 Static Join Group
To configure the PIMv6 static join, use the following command.
Command
Mode
Description
ipv6 pim static-group
X:X::X:X
Interface
[loopback
/VLAN]
Configures the PIMv6 static join.
X:X::X:X: Start/End multicast group ad-
dress
ip pim static-group range
X:X::X:X X:X::X:X
no ip pim static-group
[
X:X::X:X
| *]
Deletes the configured PIMv6 static join.
*: all addresses
no ip pim static-group
range
X:X::X:X X:X::X:X
11.3.2.8
Displaying PIMv6 Information
To display current PIM information, use the following command.
Command
Mode
Description
show
debugging
ipv6
pim
sparse-mode
Enable
Global
Shows PIM-SMv6 debugging status
show ipv6 pim interface
[
detail
]
Enable
Global
Shows PIMv6 interface information.
detail: detailed interface information
show ipv6 pim local-members
[
IFNAME
]
Shows PIMv6 local membership information.
IFNAME: interface name
show ipv6 pim mroute
[
X:X::X:X
]
[
X:X::X:X
] [
detail
]
Shows the multicast routing table.
X:X::X:X: multicast group or source address
show ipv6 pim mroute [sum-
mary]
Shows the summary of multicast routing table entry
information.
show ipv6 pim nexthop
Shows the next hop information
