![background image](http://html1.mh-extra.com/html/darwin-fitness/df-rm50/df-rm50_assembly-and-operating-instructions-manual_510607009.webp)
RM 50
9
1.3
Set-Up Place
⚠
WARNING
+
Do not place the equipment in main corridors or escape routes.
⚠
CAUTION
+
Choose a location in which to place the equipment such that there is enough free space/
clearance to the front, the rear and to the sides of the equipment. Make sure that you leave
at least 30 cm on each side of the equipment and at least 15 cm in front of and behind the
equipment as a training zone. This is the minimum required area in order to safely use the
equipment. The recommended free zone around the equipment should be at least 60 cm on
each side and 45 cm in front of and behind the equipment.
+
The training room should be well ventilated during training and not be exposed to any
draughts.
+
Choose the place in which to set up the equipment such that there is enough free space/
clearance to the front, the rear and to the sides of the equipment.
+
The set-up and mounting surface of the equipment should be flat, loadable and solid.
࣑
ATTENTION
+
The device may only be used in one building, in sufficiently tempered and dry rooms
(ambient temperatures between 10°C and 35°C). The equipment should not be used
outdoors or in rooms with high humidity (over 70%) like swimming pools.
+
A floor protective mat/equipment underlay can help to protect high-quality floor coverings
(parquet, laminate, cork, carpets) from dents and sweat and can help to level out slight
unevenness.
Training zone
Recommended free zone
Summary of Contents for DF-RM50
Page 2: ...RM 50 2 ...
Page 35: ...35 8 3 Exploded Drawing ...