DCRC Aerobatic 3D Foamy
Instruction Manual ©
Thank you very much for your purchase of the
DCRC Aerobatic 3D Airplane!
Recommended Equipment:
Radio: 4 to 6 channel w/micro receiver
Servos: 4 micro servos
Motor: Hacker A20-22L
(Other motors will work, but this is the best we have found.)
Speed Controller:Phoenix 25, Thunderbird 18,Hacker X-20
Battery: Thunder Power 3 cell 1320mAh
Propeller: APC 10 x 4.7 to 11 x 3.8 slofly
Items needed to complete construction Recommended power system and
electronics
Yard stick or tape measure Motor: Hacker A20-22L brushless
Ruler Speed control Hacker X20 or Phoneix 25 or
Foam safe medium CA and CA accelerator Thunderbird 18
Roll 1” Blenderm hinge tape Servos: 4 Sub Micro
.032 music wire Battery: 3 cell 1320 Lithium Polymer
1/8” diameter heatsrink tubing Receiver: 6 channel micro
Hobby knife with #11 blades
Double- sided tape
Recommended power system is available at
www.darrolcady.com
NOTE: THESE INSTRUCTIONS ARE GOOD FOR ALL OF OUR FOAM AIRPLANES
Tip: Before you begin assembly, remove all parts from the box, take a few minutes to read
though the instructions and familiarize yourself with the construction steps.
1
Set everything out on your construction table. This will make parts identification a lot easier!
